GE Concord 4 Installation Manual

Chapter 3: Programming
Concord 4 Installation Manual 83
Latchkey report
Shortcut: 030nnn4,
where nnn is user
number 000 to 229
Default:
On (for 000 to 005),
Off (for 006 to 229)
This setting determines whether the user code causes a latchkey report to
be sent to a pager when the code is used to change arming levels.
To assign the latchkey report attribute to user codes:
1. With the display showing USER CODES, press # and the display shows
REGULAR USER CODES.
2. Press # and the display shows USER nn (first available user number).
3. Press A or B to select the user number, then press #. The display shows
USER nnn - nnnn.
4. Press A or B until the display shows LATCHKEY OFF/ON (current
setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting. Press # and
the display shows the new setting.
Partition assign
Shortcut: 030nnn5
where nnn = user
number 000 to 229
Default: Ptn 1
This setting determines which partitions a user code can access. A code can
be assigned to all partitions if desired, making it usable at any touchpad in
any partition and able to jump to any selected partition.
To assign partitions to a user code:
1. With the display showing USER CODES, press # and the display shows
REGULAR USER CODES.
2. Press # and the display shows USER nn (first available user number).
3. Press A or B to select the user number, then press #. The display shows
USER nnn - nnnn.
4. Press A or B until the display shows PARTITION ASSIGN (current
setting).
5. Enter the desired partitions (1 to 6). The display flashes the entered
numbers. Press # and the numbers stop flashing.
Partition master
Shortcut: 0310 to 0315
Default: None
The partition master code provides access to all system operations and user
programming for a single partition. You must be in the partition of the
partition master code you wish to change.
To change the partition master code:
1. With the display showing USER CODES, press # then A or B until the
display shows PARTITION MASTER CODE.
2. Press # and the display shows PARTITION nnnn (current code).
3. Enter a new four-digit code. The display flashes the entered code. Press #
and the display shows the new code.

GE Concord 4 Specifications

General

Zones	96
Partitions	6
User Codes	230
Power Supply	16.5 VAC, 40 VA
Wireless Compatibility	Compatible with GE wireless sensors
Keypads	Up to 8
Outputs	2 onboard, expandable
Event Log	512 events
Backup Battery	12VDC, 7AH
Communication	Phone line, optional cellular or IP