K0430 Issue No. 2 46
(5) Set the variable supply voltage to 5V ± 0.1V and enter the measured full-scale
voltage applied:
(6) Press the ENTER key to accept the calibration. Press the EXIT key once to return
to the calibration menu or four times to quit the CALIBRATION and SETUP modes.
(7) Verify the instrument calibration by applying the test voltages given in Table 2
(page 48), to the voltmeter (after both voltage ranges have been calibrated).
(8) Disconnect the calibration/test equipment.
Calibration
Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176
TestEquipmentDepot.com
To Next Page
Loading...
