GE Druck DPI 880 - Default Chapter; Table of Contents

[EN] English - 1
K405 Issue 3
Table of Contents
Introduction ......................................................................... 2
Safety ..................................................................................... 2
Marks and symbols on the instrument ................................. 2
To start .................................................................................. 3
Key to figure A1/A2 (Instrument) ............................................. 3
Key to figure A3 (Display) ............................................................. 3
Prepare the instrument ................................................................ 4
Power on or off ................................................................................ 4
Set up the basic operation ......................................................... 4
Select a task (Measure and/or supply) .................................. 4
Set up the settings ......................................................................... 5
Operation .............................................................................. 6
Electrical connections .................................................................. 6
Communications port connections ........................................ 6
Change the output values .......................................................... 6
Measure/supply mA ...................................................................... 7
Measure/supply Volts or mV ..................................................... 8
Measure/supply Hz or pulses .................................................... 8
RTD/Ohms connections ............................................................... 8
Measure/simulate an RTD or Ohms ....................................... 9
Thermocouple (TC) connections .............................................. 9
Measure/simulate a Thermocouple .................................... 10
Transmitter calibration ............................................................. 10
Switch test ....................................................................................... 11
UPM Pressure measurements ............................................... 11
Error indications ........................................................................... 12
Maintenance ..................................................................... 12
Clean the unit ................................................................................ 12
Replace the batteries ................................................................. 12
Calibration ......................................................................... 13
Before you start ............................................................................ 13
Procedures: mA input ................................................................ 14
Procedures: mA output ............................................................. 14
Procedures: mV/Volts input .................................................... 14
Procedures: mV/Volts output ................................................. 15
Procedures: Hz input/output .................................................. 15
Procedures: CJ input .................................................................. 16
Procedures: RTD (Ohms) input ............................................... 16
Procedures: RTD (Ohms) output ............................................ 16
Procedures: TC (mV) input/output ........................................ 17
Procedures: IDOS UMM ............................................................. 17
Specification ...................................................................... 17
General ............................................................................................. 17
Electrical (A1 - Item 10) ............................................................. 17
Electrical connectors (A2) ........................................................ 17
Temperature ranges (RTD) ...................................................... 18
Resistance ranges (Ohms/RTD) ............................................. 18
Frequency ....................................................................................... 18
Temperature ranges (TC) ......................................................... 19
mV (TC) range ................................................................................ 19
Customer service ................................................Back cover
© 2006 General Electric Company. All rights reserved.
Trademarks
All product names are trademarks of their respective companies.