GE Druck DPI 880 - Measure;simulate a Thermocouple; Transmitter calibration

[EN] English - 7
K405 Issue 3
Operation - Measure/supply mA
To measure/supply a current:
1. Connect the instrument (Figure 1, 2 or 3) and, if
necessary, adjust the Set Up (Table 1).
2. Select the task from the task selection menu
(Table 2/3).
Note: Use the Dual Function area (
➁) to do two operations
at the same time. If the area
➁ selection is not necessary,
set this area to off (■). This saves the battery power.
3. If necessary, adjust the Settings (Table 4/5) and/or the
output values to the system (Table 7).
Figure 1: Example configuration - To measure/supply mA
with external loop power (Area
➀)
Figure 2: Example configuration - To supply mA with internal
loop power (Area
➀)
Figure 3: Example configuration - To measure mA (Dual
Function, area
➁)
Edit Settings
Maximum: 30V
a) Measure
b) Supply
Edit Settings
a) with external loop
power
b) with internal loop
power
Maximum: 30V