GEK-106310AB F650 Digital Bay Controller 5-23
5 SETTINGS 5.3 SYSTEM SETUP
5
• §Underfrequency (81U)
• §Thermal Model (49P)
• §Broken Conductor (I1I2)
• §Load Encroachment
• §Rotor Blocked (48)
• §Setting Groups
• §Recloser (79)
• §Oscillography
• §Synchrocheck (25)
• §Fault Locator
• §Directional Power (32DIR)
• §Overfrequency (81O)
• §Max. number of starts (66)
• §Fuse Failure (VTFF)
• §Watt Gnd Flt Low (32NL)
• §Watt Gnd Flt High (32NH)
• §Data Logger
• §Comparator
• §Switchgear
• §Breaker
When the Out of Service status goes to ON, or the setting has been changed to Enabled, the ready led will also change to
red color. Be careful if ready led is linked to an output, because the output will not change its state. To set an output to ready
state see factory default Logic & Configuration. Take notice that VO_000 is set to the output instead of VO_099
The following figure shows the flow chart of these states
To Next Page
Loading...
