7-32 F650 Digital Bay Controller GEK-106310AB
7.2 IEC 61850 PROFILE FOR F650 7 IEC 61850 PROTOCOL
7
2.2.5 PTUV (Undervoltage)
2.2.5.1 phsPTUV
This logical node class is used for phase undervoltage and has 3 instances inside the device.
Notes:
TmVCrv object uses Enum type setCharact_2 (See the Enum types implementation section).
ACT includes origin attribute in ST, this is implemented according to Tissue 68.
PTUV class
Attribute
Name
Attribute
Type
Explanation M/O/E Notes
PTUV Undervoltage
Data
Common Logical Node Information
Mod INC Mode M Status-only
Beh INS Behaviour M
Health INS Health M
NamPlt LPL Name plate M
Status Information
Str ACD Start M TUV PKP
Op ACT Operate M TUV OP
Blk ACT Block E TUV BLK
StrPhGn ACD Start E TUV Phase-Gnd PKP
OpPhGn ACT Operate E TUV Phase-Gnd OP
StrPhPh ACD Start E TUV Phase-Phase PKP
OpPhPh ACT Operate E TUV Phase-Phase OP
Settings
TmVCrv CURVE_2 Operating curve type O Curve ( definitive, inverse )
StrVal ASG Start value O Pickup Level (3 – 300)
TmMult ASG Time dial multiplier O Delay (0 – 900)
DeaLinVal ASG Minimum Voltage E Minimum Voltage (0 – 300)
PhLogic ING Logic E Logic (Any, Two, All phases)
InMod ING Mode E Phase-Phase, Phase-Ground
BkrMon SPG Supervised by 52 E Enable, Disable
PTUVEna SPG Function TUV enable E Function
To Next Page
Loading...
