GE F650 - Page 402

GEK-106310AB F650 Digital Bay Controller 7-33
7 IEC 61850 PROTOCOL 7.2 IEC 61850 PROFILE FOR F650
7
2.2.5.2 AuxPTUV
This logical node class is used for auxiliary undervoltage and has 3 instances inside the device.
Notes:
TmVCrv object uses Enum type setCharact_2 (See the Enum types implementation section).
ACT includes origin attribute in ST, this is implemented according to Tissue 68.
2.2.6 PTUF (UnderFrequency)
This logical node class is used for phase underfrequency and has 3 instances inside the device.
Note: ACT includes origin attribute in ST, this is implemented according to Tissue 68.
PTUV class
Attribute
Name
Attribute
Type
Explanation M/O/E Notes
PTUV Undervoltage
Data
Common Logical Node Information
Mod INC Mode M Status-only
Beh INS Behaviour M
Health INS Health M
NamPlt LPL Name plate M
Status Information
Str ACD Start M TUV PKP
Op ACT Operate M TUV OP
Blk ACT Block E TUV BLK
Settings
TmVCrv CURVE_2 Operating curve type O Curve ( definitive, inverse )
StrVal ASG Start value O Pickup Level (3 – 300)
TmMult ASG Time dial multiplier O Delay (0 – 900)
PTUVEna SPG Function TUV enable E Function
PTUF class
Attribute
Name
Attribute
Type
Explanation M/O/E Notes
PTUF OverFrequency
Data
Common Logical Node Information
Mod INC Mode M Status-only
Beh INS Behaviour M
Health INS Health M
NamPlt LPL Name plate M
Status Information
Str ACD Start M TUF PKP
Op ACD Operate M TUF OP
Blk ACT Block E TUF BLK
Settings
StrVal ASG Start value (frequency) O Pickup Level (20-65)
BlkVal ASG Voltage Block Value O Minimun Voltage (10-300)
OpDlTmms ING Operate Delay Time O Trip Delay (0-900000)
Units in miliseconds
RsDlTmms ING Reset Delay Time O Reset Delay (0-900000)
Units in miliseconds
PTUFEna SPG Function TUF enable E Function (Enable,Disable)