GE F650 - 9.2 COMMUNICATION PARAMETERS

9-2 F650 Digital Bay Controller GEK-106310AB
9.2 COMMUNICATION PARAMETERS 9 BOOTCODE AND FIRMWARE UPGRADE
9
9.2 COMMUNICATION PARAMETERS
Before proceeding with the upgrade process, it is mandatory to check the following:
1. Since F650 Setup Program acts as a TFTP sever, any other TFTP server installed in the PC must be disabled
.
Check if any other TFTP server is installed in the PC and/or if any other device is using Port 69 that it might be
installed by default during the PC startup. To disable it please proceed as follows in the PC:
•At STARTUP>MY PC>Right Mouse key>MANAGE>SERVICES & APPLICATIONS> SERVICES
• Select the operative TFTP server
• Right Mouse key>MANUAL or STOP
• Reboot PC (if MANUAL)
2. Ethernet Connection/Type
- Both boot code and firmware upgrade processes require Ethernet communications. It is
strongly recommended to use a direct connection between the PC and the relay using a Cross-Over RJ45 Ethernet
cable, instead a direct connection through a hub or switch. In no one case upgrading will be done using a Local Area
Network (LAN).
Serial RS232 Communication - Serial communication is necessary only to perform the bootware upgrade.
3. Relay IP Address
- It must be assigned a IP address to the relay in the Ethernet parameters via HMI at PRODUCT
SETUP>COMMUNICATION>ETHERNET>ETHERNET1 menu or via Enervista 650 Setup at SETPOINT>PRODUCT
SETUP>COMMUNICATION SETTINGS>NETWORK (Ethernet) 1 as shown in the Table 9–1:
Table 9–1: ETHERNET PARAMETERS
4. PC IP Address - In the case the relay has been boot code previously upgraded (section 9.2), the IP address and other
parameters already assigned in the process will be:
IP Address:192.168.37.177
Netmask:255.255.255.0
Gateway:192.168.37.10
PRODUCT SETUP>COMMUNICATION SETTINGS >NETWORK (ETHERNET) 1
NAME VALUE UNITS RANGE
IP Address Oct1 192 [0 : 255]
IP Address Oct2 168 [0 : 255]
IP Address Oct3 37 [0 : 255]
IP Address Oct4 177 [0 : 255]
Netmask Oct1 255 [0 : 255]
Netmask Oct2 255 [0 : 255]
Netmask Oct3 255 [0 : 255]
Netmask Oct4 0 [0 : 255]
Gateway IP Oct1 192 [0 : 255]
Gateway IP Oct2 168 [0 : 255]
Gateway IP Oct3 37 [0 : 255]
Gateway IP Oct4 10 [0 : 255]