GEK-106310AB F650 Digital Bay Controller 9-3
9 BOOTCODE AND FIRMWARE UPGRADE 9.2 COMMUNICATION PARAMETERS
9
Then the PC settings should be the same pattern as follows:
IP Address:192.168.37.xxx
Netmask:255.255.255.0
Gateway:192.168.37.10 (if desired)
Where XXX is a number between 0 and 255 that is not assigned to any other device to avoid collisions.
If there are not TCP/IP settings according to this pattern in the computer, it should be added (in order to communicate with
the relay) following these steps:
In the PC go to STARTUP>CONTROL PANEL>NETWORK CONNECTIONS option:
.
Figure 9–2: NETWORK MENU IN PC CONTROL PANEL
Choose NETWORK CONNECTION option and with Right mouse key select Properties. Then in CONNECTION ITEMS
window, select Internet Protocol (TCP/IP) and click Properties button (see Figure 9–3:)
To Next Page
Loading...
