9-6 F650 Digital Bay Controller GEK-106310AB
9.2 COMMUNICATION PARAMETERS 9 BOOTCODE AND FIRMWARE UPGRADE
9
5. Other Network, Communications and Data Flow checks
• According to the model number of the relay, to enable the 10/100 BASE TX-CABLE option in the relay communication
board, a specific jumper in this board must be changed. See detailed instructions in paragraph 3.4.3 of Instruction
Manual GEK-106310AB.
• IP address, netmask, gateway are correct and match the parameters used in the computer to perform the procedure.
See chapter 9.1.1 of Manual GEK-106310AB COMMUNICATION PARAMETERS.
• In the computer check that:
a)WIFI connection is disabled. Check it at STARTUP>CONTROL PANEL>NETWORK CONNECTION>WIRELESS
NETWORK (it must be disabled).
b)·There is only one communication board. Check it at STARTUP>CONTROL PANEL>NETWORK
CONNECTION>LOCAL NETWORK>Right mouse key>Properties.
c)·There is only one IP address. Check it at STARTUP>CONTROL PANEL>NETWORK CONNECTION>LOCAL
NETWORK>Right mouse key>Properties>TCP/IP>Properties button>Advance Options button
d)·Ethernet board parameters selection. Check them at STARTUP>CONTROL PANEL>NETWORK
CONNECTION>LOCAL NETWORK>Right mouse key>Properties>Comm. Board Configure button>Advance
Options Tab
o 802.1p QOS is Enabled
o Flow control is Auto
o Speed & Duplex is Auto (or 10 Mb Full)
To Next Page
Loading...
