9-8 F650 Digital Bay Controller GEK-106310AB
9.2 BOOTWARE UPGRADE 9 BOOTCODE AND FIRMWARE UPGRADE
9
Figure 9–8: WARNING MESSAGE TO SAVE SETTING AND CONFIGURE FILES
Parameters already set in step 5 will be operative during serial communications.
7. As mentioned in step 2 above if the connection is made directly from the PC to the relay it is necessary to use a 10/100
Base T crossover cable. During the upgrade, the system will show the following message indicating the procedure to
be followed.
Figure 9–9: ETHERNET AND SERIAL CONNECTIONS MESSAGE
If click Yes (Si), the next window will allow you to choose the Network adapter for your Ethernet connection to the relay.
Select the correct one in case you have more than one.
To Next Page
Loading...
