GEK-106310AB F650 Digital Bay Controller 9-9
9 BOOTCODE AND FIRMWARE UPGRADE 9.2 BOOTWARE UPGRADE
9
Figure 9–10: NETWORK ADAPTER
After selecting the Network adapter, a window to choose a temporary IP address will be shown. It is advisable to set the
same IP address that is going to be used lately in the relay for Ethernet connection.
Figure 9–11: SETTING ADDRESS
8. After entering the temporary IP Address, the next new window will require the bootware file retrieved from
www.gedigitalenergy.com and previously stored someplace in the PC.
To Next Page
Loading...
