System Setup
3-20 LOGIQ V3/V5/V5 Expert – Basic Service Manual
5726264-100 English Rev.8
3-5-7 Connections on the I/O Rear Panel
NOTE: Accessory equipment connected to the analog and digital
interfaces must be certified according to the respective IEC
standards (e.g. IEC60950 for data processing equipment and
IEC60601-1 for medical equipment). Furthermore, all complete
configurations shall comply with the valid version of the system
standard IEC60601-1. Everybody who connects additional
equipment to the signal input part or signal output part of LOGIQ
V3/V5/V5 Expert, configures a medical system, and is therefore
responsible that the Ultrasound system complies with the
requirements of the valid version of IEC60601-1. If in doubt,
consult the technical service department or your local
representative for GE.
3-5-7-1 Connect Ethernet
Connect the network cable to the Ethernet connector on the I/O
Rear Panel.
The connector is located on the rear side of LOGIQ V3/V5/V5
Expert.
3-5-7-2 Connect USB Flash Drive
NOTE: USB Flash Drive approved for LOGIQ V3/V5/V5 Expert are
verified for EMC performance according to EN55011 class B.
The use of any other USB Flash Drive will compromise this
verification, and may cause interference on LOGIQ V3/V5/V5
Expert itself, or on other electronic devices.
For approved models, please refer to Chapter 9.
Insert the USB Flash Drive in one of the USB ports on the
LOGIQ V3/V5/V5 Expert.
3-5-8 Connecting probes
Please refer to Basic User Manual on how to connect/
disconnect a probe.
3-5-9 Powering the system
Please refer to Basic User Manual on how to power the system.
To Next Page
Loading...
