5.9.9 End of Session 556
5.10 Switch Manager 556
5.10.1 Installation 557
5.10.2 Setup 558
5.10.3 Network Setup 558
5.10.4 Bandwidth Used 558
5.10.5 Reset Counters 558
5.10.6 Check for Connected Equipment 558
5.10.7 Mirroring Function 559
5.10.8 Ports On/Off 559
5.10.9 VLAN 559
5.10.10 End of Session 559
6 Simple Network Management Protocol (SNMP) 560
6.1 SNMP Management Information Bases 560
6.2 Main Processor MIBS Structure 560
6.3 Redundant Ethernet Board MIB Structure 561
6.4 Accessing the MIB 565
6.5 Main Processor SNMP Configuration 565
7 Data Protocols 567
7.1 Courier 567
7.1.1 Physical Connection and Link Layer 567
7.1.2 Courier Database 568
7.1.3 Settings Categories 568
7.1.4 Setting Changes 568
7.1.5 Event Extraction 568
7.1.6 Disturbance Record Extraction 570
7.1.7 Programmable Scheme Logic Settings 570
7.1.8 Time Synchronisation 570
7.1.9 Courier Configuration 571
7.2 IEC 60870-5-103 572
7.2.1 Physical Connection and Link Layer 572
7.2.2 Initialisation 573
7.2.3 Time Synchronisation 573
7.2.4 Spontaneous Events 573
7.2.5 General Interrogation (GI) 573
7.2.6 Cyclic Measurements 573
7.2.7 Commands 573
7.2.8 Test Mode 574
7.2.9 Disturbance Records 574
7.2.10 Command/Monitor Blocking 574
7.2.11 IEC 60870-5-103 Configuration 574
7.3 DNP 3.0 575
7.3.1 Physical Connection and Link Layer 576
7.3.2 Object 1 Binary Inputs 576
7.3.3 Object 10 Binary Outputs 576
7.3.4 Object 20 Binary Counters 577
7.3.5 Object 30 Analogue Input 577
7.3.6 Object 40 Analogue Output 578
7.3.7 Object 50 Time Synchronisation 578
7.3.8 DNP3 Device Profile 578
7.3.9 DNP3 Configuration 586
7.4 IEC 61850 587
7.4.1 Benefits of IEC 61850 588
7.4.2 IEC 61850 Interoperability 588
7.4.3 The IEC 61850 Data Model 588
7.4.4 IEC 61850 in MiCOM IEDs 589
7.4.5 IEC 61850 Data Model Implementation 590
7.4.6 IEC 61850 Communication Services Implementation 590
7.4.7 IEC 61850 Peer-to-peer (GOOSE) communications 590
P543i/P545i Contents
P54x1i-TM-EN-1 xv
To Next Page
Loading...
