GE MOA 280i - Page 121

GE Analytical Instruments ©2006 11-9 DLM 14291 Rev. A
S E L E C T
M
O D E
N I T R I C O X I D E
E X H A L A T I O N
c u r r e n t : E X H A L A T I O N
S E L E C T
M
O D E
C h a n g e t o :
N I T R I C O X I D E
E N T a c c e p t C L R r e j e c t
c u r r e n t : E X H A L A T I O N
S E L E C T
M
O D E
C u r r e n t :
N I T R I C O X I D E
C H A N G E A C C E P T E D
A N A L Y S I S S E T U P
O P E R A T I O N
I N T E R V A L
M
O D E S
O P E R A T I O N S E T U P
U N I T S
S E N S I T I V I T Y
U N I T S
C O N C E N T R A T I O N
V O L T A G E
c r n t : C O N C E N T R A T I O N
S E N S I T I V I T Y
L O
W
H I G H
c u r r e n t : L O
W
• From the Control Menu, select Setup.
• From the Setup Menu, select Change.
• From the Login menu, select Operator.
• From the Change Setup Menu, select
Analysis.
• From the Analysis Setup Menu, select Modes.
• From the Modes Menu, select Select.
• From the Select Modes Menu, if not already
select, select Nitric Oxide.
• From the Confirmation screen, press ENTER
to change the Mode.
• The menu will change briefly to indicate
that the Mode has been changed.
• Press CLEAR to return to the Analysis Setup
Menu.
• To set the Units, scroll to Operation.
• From the Operation Setup Menu, select
Units.
• From the Units Menu, Select Voltage.
• Press CLEAR to return to the Operation Setup Menu.