GE MOA 280i - Step 3- Install the Chemical Trap Mounting Bracket

GE Analytical Instruments ©2006 DLM 14291 Rev. A
4-5
Charcoal Trap
Hopcalite Trap
Mounting Bracke
t
for Charcaol Trap
Fi
g
ure 4-2: RV3 Pum
p
with Chemical and Charcoal Tra
p
s.
o-ring on the pump inlet. Place the clamp over the inlet fitting, o-ring and barbed
fitting and secure with the screw and wing nut finger-tight.
Step 3- Install the Chemical Trap Mounting Bracket
Locate the Allen wrench, black Allen screws and trap mounting bracket in the
pump accessories kit. Use the Allen wrench to remove the two screws on the rear
of the top plate of the pump. Insert the black Allen screws through the holes in
the bracket and connect to the pump with bracket’s clip on the same side as the
pump inlet (Figure 4-2).
Locate the Hopcalite trap in the NOA accessories box and the short length of clear