GE MOA 280i - Setting the Clock

GE Analytical Instruments ©2006 DLM 14291 Rev. A
4-13
M
A I N
M
E N U
A N A L Y S I S C A L I B R A T I O N
C O N T R O L
M
E S S A G E S
M
A I N T E N A N C E
0 4 J U L 0 0 1 2 : 3 4 : 5 6
C O N T R O L
M
E T H O D
S E T U P
S T A T U S
S E T U P
C H A N G E
V I E
W
P R I N T
L O G I N
O P E R A T O R
S I E V E R S
C H A N G E S E T U P
A N A L Y S I S
C O N F I G U R A T I O N
C O N F I G U R A T I O N
C O
M
P O R T
P R E S S U N I T S
D A T E & T I
M
E
C U R R E N T D A T E & T I
M
E
0 4 J U L 0 0 0 8 : 0 8 : 4 2
↓ ↑
s e l e c t f i e l d
E N T c h a n g e C L R e s c a p e
C U R R E N T D A T E & T I
M
E
0 4 J U L 0 0 1 0 : 0 8 : 4 2
↓ ↑
s c r o l l d a t e / t i m e
E N T a c c e p t C L R r e j e c t
pin to 25 pin Serial adapter for use with the
NOA. These adapters are available from most
computer stores. For Apple computers, the
cable is a 9 pin male to 8 pin DIM (ACH 14000).
Connect the 9 pin male end to the NOA port
and secure with a screwdriver. Connect the DIM
end to either the printer or modem port on the
Macintosh. Newer Macs do not have serial ports
and either a USB to serial adapter or a serial
port card is required. Contact Sievers
Instruments for more information on these
devices.
Printer – a Centronics 25 pin printer connector
is located below the RS-232. The NOA can be
connected to any 80 column printer using the
cable that came with the printer.
Analog Output – the analog signal from the NOA
is the BNC connector to the right of the RS-232
output. This is a 0-1V output directly from the
PMT amplifier and can be set to a 0-10V output
using a switch on the amplifier. A cable (ASM
00165) with a BNC connector and spade lugs is
available from Sievers Instruments
Setting the Clock
To set the clock on the NOA:
• From the Main Menu use the Arrow buttons
to scroll to Control and press ENTER to
display the Control Menu.