GE Monogram Wall Oven - How to set the oven for convection roasting when using the probe

Using the Convection Oven
I,l?lll Ovet_
How to set
the oven jot
convection
roasting
when using
the probe
CAUTION:To prevent possible burns, do
not unplug the probe from the oven outlet
until the oven has cooled. Do not store the
probe in the oven.
For be,sl re,sull,s when roa,sli*_g" larg'e lud¢ey,s and
roa,sl,s, we recommend u,sing lhe probe included in
1 Place the ottset shelf in the lowest position
(A). Insert the probe into the nieat.
2 Phig the probe into the outlet in the oven.
Make sure it is pushed all the way in.
Close the ()veil door.
3 Press the CONVECTION ROAST pad.
4 Press the nuinber pads to set the desired
oven telllpei'at tli'e.
To change the ()veil teini)eratui'e during the
Convection Roast cycle, press the CONVECTION
ROAST pad and then press the nuniber pads
to set the new desired teini)erature.
5 Press the PROBE pad.
6 Press the nuniber pads to set the desired
internal nieat teini)erature,
7 Press the START pad.
The di,q)lay will flash Iq?OI3E and the ove_ (o_Hnd
will sit€hal !/the probe i,s in,serled into the out#t, and
you have not set a probe lempemtun, and pre,_sed the
$7;4 R 7" Dad,
When the ()veil starts to heat, the word i,O
will be in the display.
Mter the internal teini)erature of the nieat
reaches 100°E, the changing internal
teini)erature will be shown in the display.
8 When the internal tenii)erature of the ineat
reaches the nuinber you have set, the probe
and tile ()veil ttli'n ()t_ and tile ()veil conti'ol
signals. To stop the signal, press the
CLF_R/OFF pad. Use hot pads to reniove
the probe froni the tood. Do not tlse tongs
to pull on it--they nIight daniage it.
g the/,*_*/)ei.,re._oved/}**.zthefi*odI<fi*retheft.a!
lempemhm, is n, aehed, a lone will sound and the
display will /la,sh until the p*vbe is removed /h*m
the oven.
@
@®®®®®®®@®
G
@®®®®®@®@®
@
NOTE:
• };<*Itwill hear afire while co&it_t_" wilh this/kature.
The /hn will stop when the door is opened bat the
heat will not tur_ (:_/:
• };<*It_an u,se the timer even lhout{'h you (alzlzol it,se
limed oven operations.
• On double oven models, you will not be able to u,s*,
the probe in the upper oven during" limed oven
operations. This is because with the probe yoa an,
eookil_t{"b3' lemDemlufe mlher lhan time.
28