EPM 2200 POWER METER – INSTRUCTION MANUAL 3–1
EPM 2200 Power Meter
Chapter 3: Mechanical Installation
GE
Grid Solutions
Mechanical Installation
3.1 Introduction
The EPM 2200 meter can be installed using a standard ANSI C39.1 (4" Round) or an IEC
92mm DIN (Square) form. In new installations, simply use existing DIN or ANSI punches. For
existing panels, pull out old analog meters and replace with the EPM 2200 meter. The
various models use the same installation. See Chapter 4 for wiring diagrams.
POTENTIAL ELECTRICAL EXPOSURE - The EPM 2200 must be installed in an electrical
enclosure where any access to live electrical wiring is restricted only to authorized
service personnel.
To Next Page
Loading...
