CHAPTER 7: COM OPTION B: BACNET MS/TP WITH MODBUS TCP/IP USING THE EPM 2200 METER’S WEB INTERFACE
EPM 2200 POWER METER – INSTRUCTION MANUAL 7–11
7.3.1 Resetting the Ethernet Card
The Ethernet card’s Reset Button is accessed from the back of the EPM 2200 meter. See
figure below for button location.
Figure 7-1: Backplate of EPM 2200 meter, showing Reset Button placement
Using an implement such as a ballpoint pen tip, press and hold the Reset button for 30
seconds. The Ethernet card will be reset to its default settings.
7.4 Using the EPM 2200 Meter’s Web Interface
As shown in Section 7.3, you can use the meter’s web interface to change the IP address
and other Network parameters. You can also view information and readings using the web
interface. This section explains the web pages other than the BACnet MS/TP Settings and
Activate Configuration web pages, which are explained in Section 7.3.
7.4.1 Home web page
The Home web page is shown at the top of page 7–8. It is the first page you see when you
connect to the meter.
Note
To access this web page from any of the other pages, click Home on the left side of the
page.
To Next Page
Loading...
