6–20 EPM 2200 POWER METER – INSTRUCTION MANUAL
GE COMMUNICATOR PROGRAMMING OVERVIEW CHAPTER 6: USING THE METER
• Baud Rate (9600 to 57600)
• Response Delay (0-750 msec)
9. When changes are complete, click Update to send a new profile to the meter.
10. Click Cancel to exit the Profile or click other tabs to update other aspects of the Profile
(see the next section).
6.4.3 Device Profile Settings
Only the basic Device Profile settings are explained in this manual. Refer to the GE
Communicator Instruction Manual for details of the meter’s Device Profile.
The Device Profile settings are described in the following sections. After programming the
Device Profile, click the options at the bottom of the screen to continue:
• Update to send the new Profile to the connected meter.
Note
If the Update fails, the software asks if you want to try to Update again.
• Cancel to exit the EPM 2200 Device Profile screen.
• Load to load new Device Profile settings from a file.
• Save to save the Device Profile settings in a file.
• Report to view or print a summary of the Device Profile settings.
• Help to view the full GE Communicator Instruction Manual
Note
If you click Cancel before Save or Update, you will lose any changes you have made to the
Device Profile.
SCALING (CT, PT Ratios and System Wiring)
To Next Page
Loading...
