CHAPTER 7: COM OPTION B: BACNET MS/TP WITH MODBUS TCP/IP USING THE EPM 2200 IN A BACNET APPLICATION
EPM 2200 POWER METER – INSTRUCTION MANUAL 7–15
7.4.5 Reset Configuration web page
•Click Reset Configuration on the left side of the web page if you want to set the
configuration back to its default or last configuration. You will see the page shown
below.
• Click the Restore Default button to restore all settings to the factory
default values.
• Click the Discard Changes button to restore all settings to the last saved
configuration.
7.5 Using the EPM 2200 in a BACnet Application
Once you have configured the EPM 2200 meter, you can connect the RS485 port to your
BACnet implementation and use it as a standard BACnet client. As there are many kinds of
BACnet applications, we recommend you consult your application’s instructions for details.
In addition to integrating with BACnet applications, the EPM 2200 meter can also be
accessed through GE Communicator software (see the GE Communicator Instruction
Manual). Additionally, all of the BACnet data can be polled through the Modbus registers
(see Appendix B: “Modbus Mapping for EPM 2200” on page 1 for the Modbus map).
To Next Page
Loading...
