6–8 EPM 2200 POWER METER – INSTRUCTION MANUAL
PROGRAMMING USING THE FACEPLATE CHAPTER 6: USING THE METER
7. Use the RIGHT button to scroll to change the value from no to YES.
8. When the Stor ALL? YES message is displayed, press ENTER to change the
setting.
The Stor ALL donE message will appear and the meter will reset.
6.1.8 Configuring the Scroll Feature
When in Auto Scroll mode, the meter performs a scrolling display, showing each
parameter for 7 seconds, with a 1 second pause between parameters. The parameters
that the meter displays are determined by the following:
• They have been selected through software (refer to the GE Communicator Instruction
Manual).
• They are available through the appropriate software options (see 2.1.2 Order Codes on
page 2–2).
Use the following procedure to configure the scroll feature.
1. Press the ENTER button to display the SCrL no message.
2. Press the RIGHT button to change the display to SCrL YES as shown below.
To Next Page
Loading...
