CHAPTER 6: USING THE METER PROGRAMMING USING THE FACEPLATE
EPM 2200 POWER METER – INSTRUCTION MANUAL 6–3
Using Menu, Enter, Down and Right Buttons, perform the following functions:
• View Meter Information
• Enter Display Modes
• Configure Parameters (Password Protected)
•Perform Resets
• Perform LED Checks
• Change Settings
• View Parameter Values
• Scroll Parameter Values
The EPM 2200 has three MODES:
• Operating Mode (Default)
• Reset Mode
• Configuration Mode.
The MENU, ENTER, DOWN and RIGHT buttons navigate through the modes and navigate
through all the screens in each mode.
In this chapter, a typical set up will be demonstrated. Other settings are possible. The
complete Navigation Map for the Display Modes is in Appendix A of this manual. The meter
can also be configured with software (see GE Communicator Instruction Manual).
6.1.3 Start Up
Upon Power Up, the meter will display a sequence of screens. The sequence includes the
following screens:
• Lamp Test Screen where all LEDs are lighted
• Lamp Test Screen where all digits are lighted
• Firmware Screen showing build number
• Error Screen (if an error exists)
If auto-scrolling is enabled, the EPM 2200 will then automatically Auto-Scroll the
Parameter Designators on the right side of the front panel. Values are displayed for each
parameter.
The KILO or MEGA LED lights, showing the scale for the Wh, VARh and VAh readings.
An example of a Wh reading is shown here.
To Next Page
Loading...
