GE Multilin EPM 2200 - Page 77

CHAPTER 6: USING THE METER GE COMMUNICATOR PROGRAMMING OVERVIEW
EPM 2200 POWER METER – INSTRUCTION MANUAL 6–19
5. You will see the Device Status screen, confirming connection to your meter. Click OK.
Figure 6-11: Device Status screen
6. Click the Profile icon in the Icon Bar.
7. You will see the Device Profile screen. The tabs at the top of the screen allow you to
navigate between setting screens (see below).
8. Click the Communication tab. The Communication Settings appear.
Use drop-down menus to change settings of the RS485 port (Com 2) if you have an
EPM 2200 meter with Com Option S: RS485/KYZ output.
NOTE
Note
• COM1 is not used by the EPM 2200 meter with Com Option S.
• If you have an EPM 2200 meter with Com Option B (BACnet), the RS485 port is used
only for BACnet and is not programmed.
Valid Communication Settings
• COM2 (RS485)
• (1-247)
• Protocol (Modbus RTU, ASCII)
Click the Profile Icon