6–18 EPM 2200 POWER METER – INSTRUCTION MANUAL
GE COMMUNICATOR PROGRAMMING OVERVIEW CHAPTER 6: USING THE METER
3. The Connect screen opens.
• For Communication Option S (connecting through the RS485 port) make sure your
settings are the same as shown here. Use the pull-down windows to make
changes, if necessary.
Figure 6-9: Serial Port settings
• For Communication Option B (connecting through the Ethernet port) your settings
screen is shown below. Enter the address of the Ethernet card.
Figure 6-10: Network Port settings
(See 7.3 Configuring Com Option B: BACnet MS/TP with Modbus TCP/IP on page 7–4
for Ethernet configuration details.)
4. Click the Connect button. If you have a problem connecting, you may have to
disconnect power to the meter, then reconnect power and click the Connect button,
again.
To Next Page
Loading...
