GE Multilin EPM 2200 - Page 89

CHAPTER 7: COM OPTION B: BACNET MS/TP WITH MODBUS TCP/IP CONFIGURING COM OPTION B: BACNET MS/TP WITH MODBUS TCP/IP
EPM 2200 POWER METER – INSTRUCTION MANUAL 7–7
•Click the Use the Following IP Address radio button and enter:
• IP Address: 10.0.0.100
• Subnet Mask: 255.255.255.0
•Click OK.
The Local Area Connection Properties screen redisplays.
•Click OK.
2. Use an Ethernet cable to connect the meter to your LAN port.
3. Open your web browser and connect to the meter at the default address by typing
http://10.0.0.1.
NOTE
Note
If this doesn’t work, reset the meter to this default address by pressing the Reset button for
30 seconds. See “Resetting the Ethernet Card” on page 11 for instructions.
4. You will see a User Authentication screen. Enter the following default settings:
•User name: admin
• Password: admin
Insert Ethernet
Cable here