EasyManua.ls Logo

GE Multilin PQM - Page 227

GE Multilin PQM
348 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CHAPTER 7: MODBUS COMMUNICATIONS MODBUS MEMORY MAP
PQM POWER QUALITY METER – INSTRUCTION MANUAL 7–47
DATA
LOGGER
LOG 1
HEADER
0A90
0A91
Log 1 Time Interval (high)
Log 1 Time Interval (low)
--- --- s F3 N/A
0A92 Log 1 Time - Hours/Minutes --- --- --- F22 N/A
0A93 Log 1 Time - Seconds --- --- --- F23 N/A
0A94 Log 1 Date - Month/Day --- --- --- F24 N/A
0A95 Log 1 Date - Year --- --- --- F25 N/A
0A96 Log 1 Start Address --- --- --- F1 0
0A97 Log 1 Record Size --- --- bytes F1 0
0A98 Log 1 Total Records --- --- --- F1 0
0A99 Log 1 Pointer to First Item of First Record --- --- --- F1 0
0A9A Log 1 Pointer to 1st Item of Record After
Last
--- --- --- F1 0
0A9B Log 1 Status --- --- --- F35 0 = STOPPED
0A9C Log 1 Records Used --- --- --- F1 0
0A9D
0A9E
Log 1 Time Until next Reading (high)
Log 1 Time Until next Reading (low)
--- --- s F3 N/A
0A9F Reserved
to
0AA7 Reserved
DATA
LOGGER
LOG 2
HEADER
0AA8 Log 2 Time Interval (high) --- --- s F3 N/A
0AA9 Log 2 Time Interval (low) --- --- s F3 N/A
0AAA Log 2 Time - Hours/Minutes --- --- --- F22 N/A
0AAB Log 2 Time - Seconds --- --- --- F23 N/A
0AAC Log 2 Date - Month/Day --- --- --- F24 N/A
0AAD Log 2 Date - Year --- --- --- F25 N/A
0AAE Log 2 Start Address --- --- --- F1 0
0AAF Log 2 Record Size --- --- bytes F1 0
0AB0 Log 2 Total Records --- --- --- F1 0
0AB1 Log 2 Pointer to First Item of First Record --- --- --- F1 0
0AB2 Log 2 Pointer to 1st Item of Record After
Last
--- --- --- F1 0
0AB3 Log 2 Status --- --- --- F35 0 = STOPPED
0AB4 Log 2 Records Used --- --- --- F1 0
0AB5
0AB6
Log 2 Time Until next Reading (high)
Log 2 Time Until next Reading (low)
--- --- s F3 N/A
0AB7 Reserved
to
0ACF Reserved
Table 7–10: PQM Memory Map (Sheet 31 of 55)
GROUP ADDR
(HEX)
DESCRIPTION RANGE STEP
VALUE
UNITS and
SCALE
FORMAT FACTORY
DEFAULT
Notes:* Data type depends on the Command Operation Code.** Any valid Actual Values or Setpoints address.
*** Maximum Setpoint value represents OFF.**** Minimum Setpoint value represents “OFF”.
***** Maximum Setpoint value represents “UNLIMITED”.****** Applicable to older revisions with VFD display only
Courtesy of NationalSwitchgear.com

Table of Contents

Related product manuals