GE Multilin PQM - Page 293

CHAPTER 8: DNP COMMUNICATIONS DNP 3.0 PROTOCOL
PQM POWER QUALITY METER – INSTRUCTION MANUAL 8–19
146 0000
Multilin Product Device
Code
always 65 - F1 -
147 0001 Hardware Version Code - - F5 -
148 0002
Main Software Version
Code
--F1-
149 0003
Modification File
Number 1
--F1-
150 0004
Boot Software Version
Code
--F1-
151 0005
Supervisor Processor
Version Code
--F1-
152 0007
Modification File
Number 2
--F1-
153 0008
Modification File
Number 3
--F1-
154 0009
Modification File
Number 4
--F1-
155 000A
Modification File
Number 5
--F1-
156 0020
Serial Number
Character 1 and 2
--F10-
157 0021
Serial Number
Character 3 and 4
--F10-
158 0022
Serial Number
Character 5 and 6
--F10-
159 0023
Serial Number
Character 7 and 8
--F10-
160 0030
Manufacture Month/
Day
--F24-
161 0031 Manufacture Year - - F25 -
162 0032 Calibration Month/Day - - F24 -
163 0033 Calibration Year - - F25 -
* This point is used to reconstruct neutral current values from the 1,000ths per-unit quantities given in
the other points. Multiply the particular point by this one, and divide by 1000 to get amps.
The VT Ratio setpoint is always reported, but is not used if a direct (i.e., without VTs) voltage wiring
scheme is configured. In this case the VT Ratio setpoint is ignored, and a ratio of 1.0:1 is used in the
PQM.
Table 8–4: Point List for Analog Input/Output Change (Sheet 9 of 9)
POINT MOBUS
REG
DESCRIPTION UNIT /
VALUE
DEADBAND FORMAT
CODE
EVENT
CLASS
ASSIGNED
TO
see footnote explanations at the end of the table
Courtesy of NationalSwitchgear.com