GE Multilin PQM - Chapter 9: Commissioning; 9.1 Commissioning

PQM POWER QUALITY METER – INSTRUCTION MANUAL 9–1
PQM Power Quality Meter
Chapter 9: Commissioning
GE Consumer & Industrial
Multilin
STATUS COMMUNICATE RELAYS
VALUE
MESSAGE
ACTUAL
SETPOINT
RESET
STORE
SIMULATION
ALARM
SELF TEST
PROGRAM
TX2
TX1
RX2
RX1
AUX2
ALARM
AUX3
AUX1
PQM Power Quality Meter
g
Ia = 100 Ib = 102
Ic = 100 AMPS
Commission ing
9.1 Commissioning
Table 9–1: PQM Setpoints (Sheet 1 of 12)
S1 PQM SETUP
PREFERENCES
DEFAULT MESSAGE TIME min.
DEFAULT MESSAGE BRIGHTNESS
(applicable to older units with VFD
only)
%
DISPLAY FILTER CONSTANT
SETPOINT ACCESS
SETPOINT ACCESS
ENTER SETPOINT ACCESS CODE
SETPOINT ACCESS ON FOR min.
CHANGE ACCESS CODE
ENTER NEW ACCESS CODE
RE-ENTER NEW ACCESS CODE
ENCRYPTED ACCESS CODE
COM 1 RS485 PORT
MODBUS COMM ADDRESS
COM 1 BAUD RATE baud
COM 1 PARITY
Courtesy of NationalSwitchgear.com