9–2 PQM POWER QUALITY METER – INSTRUCTION MANUAL
COMMISSIONING CHAPTER 9: COMMISSIONING
COM 2 RS485 PORT
COM 2 BAUD RATE baud
COM 2 PARITY
FRONT PANEL RS232 PORT
RS232 BAUD RATE baud
RS232 PARITY
DNP 3.0 CONFIGURATION
DNP PORT
DNP SLAVE ADDRESS
DNP TURNAROUND TIME ms
CLOCK
SET TIME hh:mm:ss
SET TIME mm:dd:yyyy
CALCULATION PARAMETERS
EXTRACT FUNDAMENTAL
CURRENT DEMAND TYPE
CURRENT DEMAND TIME INTERVAL min.
POWER DEMAND TYPE
S1 PQM SETUP continued
POWER DEMAND TIME INTERVAL min.
ENERGY COST PER kWh cents
TARIFF PERIOD 1 START TIME min.
TARIFF PERIOD 1 COST PER kWh cents
TARIFF PERIOD 2 START TIME min.
TARIFF PERIOD 2 COST PER kWh cents
TARIFF PERIOD 3 START TIME min.
TARIFF PERIOD 3 COST PER kWh cents
EVENT RECORDER
EVENT RECORDER OPERATION
TRACE MEMORY
TRACE MEMORY USAGE cycles
TRACE MEMORY TRIGGER MODE
Table 9–1: PQM Setpoints (Sheet 2 of 12)
Courtesy of NationalSwitchgear.com
To Next Page
Loading...
