PACE Pressure Controller User Manual
[EN] English 6 - 11 K0443 Revision A
Global set-up
PIN protected menu (Ref: Supervisor set-up, Section 6.7).
Status
The display shows the following:
a. Instrument
• Module 1 (Module2 if fitted)
• Control sensor
• +ve source sensor
• -ve source sensor
• Barometric sensor (Optional)
b. Software build - read only data
c. Hardware build - read only data
d. History - read only data
e. Communications
f. Current set-up - read only data
g. Use log - read only data
h. Software options - read only data
i. Summary - read only data.
Vent set-up
Use the vent set-up to prevent damage to rate-sensitive equipment connected to this
controller. The vent slew rate setting is independent of the controller slew rate settings.
6.6 Global set-up
Supervisor set-up
PIN protected menu (Ref: Supervisor set-up, Section 6.7).
Calibration
PIN protected menu.
Save/recall user set-up
Save user set-up
Recall user set-up
Display
Resolution
Backlight
Audio volume
Status area
Screen mode (PACE 6000 only)
To Next Page
Loading...
Need help?
General
