– 14 –
Note: The drum seal can be replaced by extracting
the seal from the channel located in the air duct
assembly.
3. Unhook the plastic tabs on each side of the
air duct assembly and remove the air duct
assembly.
To remove the drum slide assembly:
Remove the control, top, and front panels. (See 1.
Control Panel, Top Panel, and Front Panel.)
Remove the air duct assembly. (See 2. Air Duct
Assembly.)
Grasp the top of the drum slide assembly and 3.
pull down and inward to release the assembly
from the 2 tabs located at the top of the front
panel.
Support Slides
Guide Slide
Guide Slide
Drum Slide Assembly
The drum slide assembly is located on the back
side of the front panel and utilizes 4 drum slides.
Two white outer slides are used as guides, and 2
dark color center (top) slides are used to support the
weight of the drum. When replacing the slides, the
dark-colored support slides must be used to replace
the top support slides. Guide slides may also be
replaced with support slides.
Caution: Do not replace the center (top) support
slides with the white guide slides. Damage to the
dryer will result.
Tab
Tab
Tab
Tab
Drum Seal
Air Duct Assembly
The air duct assembly houses the lint fi lter, drum
seal, and the 2 sensor rods. It is located on the back
side of the front panel.
Note: The sensor rods are part of the air duct
assembly. To replace the sensor rods, the air duct
assembly must be replaced.
To remove the air duct assembly:
Remove the control, top, and front panels. (See 1.
Control Panel, Top Panel, and Front Panel.)
Remove the 2 Phillips-head screws that attach 2.
the air duct assembly to the front panel.
(Continued Next Page)
To Next Page
Loading...
Need help?
General