– 34 –
Display Board
The display board is mounted on the underside of
the plastic housing that holds the control board
assembly. The display board snaps onto the plastic
housing via 2 plastic tabs.
To remove the display board:
Caution: To avoid marring the control panel, place
the panel face down on a protective surface.
Remove the control and top panels. (See 1.
Control
Panel and Top Panel.)
Remove the 5 Phillips-head screws that attach 2.
the control board plastic housing to the control
panel. Remove the housing.
4. Remove the wire harness.
5. Release the display board from the 2 plastic
tabs that attach the display board to the plastic
housing.
3. Turn the plastic housing over to expose the
display board.
Tab
Tab
Display Board
To Next Page
Loading...
