GE T60

GE Multilin T60 Transformer Protection System H-5
APPENDIX H H.1 CHANGE NOTES
H
5- 5-297 Add Added new CyberSentry security section and main menu, local passwords, session settings,
restore defaults, and supervisory subsections to Chapter 5
6-1 6-1 Update Update Actual Values main menu to include Real Time Clock Synchronization submenu
6- 6-7 Add Added new section for Real Time Clock synchronizing consisting of the menu of settings and the
setting descriptions
6- 6-12 Add Added new section 6.2.19 Remaining Connection Status
7- 7-1 Add Added Security command to the Commands main menu
7- 7-3 Add Added Reboot Relay command and description to the Relay Maintenance menu items
7- 7- Add Added Security menu and submenu commands and descriptions to the Command menu
7- 7- Add Added to Minor self-test error message **Bad PTP Signal**
8- 8-4 Add Added new section for CyberSentry software option with overview and security menu subsections
10- 10-3 Add Added tables for radius server settings, general security settings, and security alarm settings
10- 10-2 Add Added Figure 10-1 Security Settings Menu
A- A- Add Added Flexanalog item PTP–IRIG-B Delta to Table A-1: FlexAnalog Data Items
B-8 B-8 Update Updated Modbus memory map table to include port 0 for Modbus slave address, TCP, DNP,
HTTP, TFTP, MMS, and removed references to COM 1 RS485 port
C-23 C-23 Update Updated tables in sections C.6.3 ACSI Services Conformance Statement and C.7.1 Logical
Nodes Table
Table H–6: MAJOR UPDATES FOR T60 MANUAL REVISION Y1 (Sheet 3 of 3)
PAGE
(X2)
PAGE
(Y1)
CHANGE DESCRIPTION