– 57 –
18. Attach the washer control board to the new
backsplash by replacing the 4 Phillips head
screws removed from the washer control
board earlier.
23. Secure the new backsplash to the washer
using the 2 Phillips head screws removed
earlier.
22. Insert the tabs on the bottom front of the new
backsplash into the slots on the washer and
rotate the backsplash into place.
21. Place the gray wire from the serial port under
the strain relief of the new backsplash.
24. Reconnect house utilities.
25. Plug the washer and dryer back in.
19. Connect the washer control board to the new
backsplash by sliding the ribbon connector on
the new backsplash onto the metal pins on the
control board and pushing in. Make sure the
ribbon is not twisted before inserting the
connector.
Strain Relief
Screws
20. Secure the new washer backsplash to the
rear cover using the 2 Phillips head screws
removed earlier.
To Next Page
Loading...
