Maintenance
Disposal
38
Operating Instructions · VARIVENT
®
Vacuum Valve V
Edition 2016-06-30
2. Secure the proximity switch (15) using a hex. nut (15.1).
After securing the proximity switch (15), there must be a gap of 1 to 1.5mm between
areas (B) and (C) on the screw (19). If the gap is smaller or larger than 1 to 1.5mm,
the screw (19) must be adjusted.
Done
Disposal
Dispose of the machine at the end of its life cycle in an environmentally friendly manner.
Observe the statutory waste disposal regulations applicable at the place of installation.
The valve is made of the following materials:
• Metals
• Synthetic materials
• Electronic parts
• Lubricants containing oil and grease
Separate the different materials and dispose of them correctly sorted. Also observe the
instructions regarding disposal in the operating instructions for the individual compo-
nents.
To Next Page
Loading...
