46
SHENZHEN GETECH TECHNOLOGY CO., LTD
(Picture 9-3) (Picture 9-4)
See picture (9-5), Adjust discharge change ratio of each extruder in a range of heights as
needed, click the E0, E1, E2 button in the “Preview” window in the upper right corner to
enter the color selection interface, as shown in Picture (9-6). The color here should be
selected according to the actual filament color of each extruder, and then click "Select" to
confirm. After selecting corresponding color to each extruder, click the “Preview” button
below to display color change of the current configuration in the box on the right side of the
small window.
To Next Page
Loading...
