Shenzhen Getech Technology Co.,Ltd
24
（Picture 7-7）
2) Click “Move” to its interface, see picture (7-8).
（Picture 7-8）
Please choose its precision firstly before moving axes. There are
“30/10/1/0.5/0.1mm”available.And control every axis moving. Moreover, when the lower
right-hand corner motor status is in the "Enable" state, motor is locked. When “Disable” releases,
motor is unlocked, you can move every axis by hand.
3) Click “Motion Parameter”, it will enter motion parameter interface. See picture (7-9).
To Next Page
