QS
29
—————— Quick Start up ——————
1.11 QUICK TUNING GUIDE FOR
FACTORY CONFIGURED (OR PRE-
CONFIGURED) DRIVES
When the drive configuration has already been set
and you are simply tuning a motor which has not
been tuned, you can ignore most of the preceding
procedure, since it has already been done, but unless
you are certain, it is recommended that you go
through the steps anyway, just to verify that the data
shown in the various locations indicated is OK. You
can just use the
[Left arrow] key rather than the
[Enter] key in all the steps in which the entry is found
to be correct. Start with step 4 of the full procedure
and do not default the parameters to factory
parameters. If there is any question about whether
the existing setup should be saved or not, then use
the configuration tool software that came with the
drive and save the file to a PC first so it can be used
later. Normally, drives configured at the factory will
have the setup file already saved to your configura-
tion tool diskette.
To Next Page
Loading...
Need help?
General
