13
SuperCorona
Field of application
The SuperCorona is an optional device for the powder gun, designed to
improve surface appearance quality.
When coating wheel rims, drawers, radiators, lamps etc. an exceptional
surface appearance quality is generally requried, also when higher then
normal coating layer thicknesses are required. The SuperCorona assist
the gun in acheiving the desired results.
The SuperCorona works with a variety of powders to reduce or eliminate
"orange peel" finish typlically associated with overcharing. Additionally the
SuperCorona can be used with structure (or textured) powder coatings to
assist with reduce or eliminate the "picture frame effect".
The performance of the gun with SuperCorona is convincing due to its
very good charging and very high deposition rate as well as an improved
penetration into Faraday cages. The distance between nozzle and
workpiece can be reduced to 100 mm without influencing the surface
finish.
: SuperCorona – retrofit
Due to its modular structure, the gun can be extended quickly and easily
with the lightweight SuperCorona (approx. 35 g). The gun remains repair-
friendly and easy to maintain even after reconfiguration.
SuperCorona assembly
In order to achieve the desired SuperCorona effect, the length of
the SuperCorona must be taken into account when choosing.
The length of the SuperCorona depends on the nozzle used (flat
or round jet nozzle) and on the extensions.
– see Spare parts list "SuperCorona"
Before fitting the SuperCorona, make sure that the connection and the
plug-in connector are free from grease and powder, otherwise the electric
contact cannot be guaranteed.
1.
To Next Page
Loading...
