Rev. 00 12/23
OptiGun GA04-E Maintenance / Repairs
Any unauthorized modifications and alterations to the product are
not permitted for safety reasons and exclude the manufacturer’s
liability for any resulting damage!
Regular and conscientious cleaning and maintenance increase
the service life of the product and ensure consistent high coating
quality!
– The parts to be replaced during maintenance work are available
as spare parts. These parts can be found in the appropriate
spare parts list!
Reinigung
Cleaning
Gun cleaning
Impermissible solvents
The following solvents may not be used to clean the gun:
► Ethylene chloride, acetone, ethyl acetate, methyl ethyl ketone,
methylene chloride, premium gasoline, turpentine,
tetrachloromethane, toluene, trichloroethylene, xylene!
Only cleaning agents with a flash point of a least 5 Kelvin above
the ambient temperature, or cleaning places with technical
ventilation are allowed!
Before cleaning the powder gun, switch off the control unit. The
compressed air used for cleaning must be free of oil and water!
Daily:
1. Blow off the outside of the gun and wipe, clean etc.
To Next Page
Loading...
