To Next PageTo Next PageWhat to do if my Generac Power Systems GP engine will not crank?
If your Generac Power Systems Portable Generator engine won't crank, consider these potential causes: * **Blown fuse:** If the 10 amp fuse at the rear of the generator control panel has melted open, replace it with an identical 10-amp replacement fuse. * **Weak or dead battery:** Recharge or replace the battery.
How to fix Generac Power Systems GP Portable Generator engine that lacks power?
If your Generac Power Systems Portable Generator engine lacks power, the following could be the reasons: * **Load is too high:** See “Don’t Overload the Generator”. * **Dirty air filter:** Replace the air filter. If these steps don't resolve the issue, the engine may need servicing by an Authorized Service Facility.
What to do if Generac Power Systems GP Portable Generator engine runs good but bogs down when loads are connected?
If your Generac Power Systems Portable Generator engine runs well but bogs down when loads are connected, here are possible causes: * **Short circuit in a connected load:** Disconnect the electrical load that has a short circuit. * **Generator is overloaded:** See “Don’t Overload the Generator”. For issues related to engine speed or a shorted generator circuit, contact an Authorized Service Facility.
Why does my Generac Power Systems GP Portable Generator engine shut down during operation?
Your Generac Power Systems Portable Generator's engine might shut down for a few reasons: * **Out of gasoline:** Refill the fuel tank. * **Low oil level:** Add oil to the crankcase to the correct level. If neither of these is the issue, there may be a fault in the engine, and you should contact an Authorized Service Facility.
What to do if my Generac Power Systems Portable Generator engine is running, but there is no AC output?
If your Generac Power Systems Portable Generator's engine runs but has no AC output, consider these potential causes and solutions: * **Circuit breaker is open:** Reset the circuit breaker. * **Poor connection or defective cord set:** Check and repair the connection or cord set. * **Connected device is faulty:** Connect a device known to be in good working condition. If the issue persists, there may be a fault in the generator, and you should contact an Authorized Service Facility.
How to fix a Generac Power Systems GP Portable Generator that hunts or falters?
If your Generac Power Systems Portable Generator engine "hunts" or falters, it might be because: * The choke is opened too soon: Move the choke to the halfway position until the engine runs smoothly. * Carburetor is running too rich or too lean: Contact Authorized Service Facility.
Why does my Generac Power Systems Portable Generator lack power?
If your Generac Power Systems Portable Generator engine lacks power, consider the following: * The load is too high: Reduce the load (see “Don’t Overload the Generator”). * Dirty air filter: Clean or replace the air filter. * Engine needs service: Contact an Authorized Service Facility.
What to do if my Generac Power Systems GP bogs down under load?
If your Generac Power Systems Portable Generator runs well but bogs down when loads are connected, consider these potential issues: * Short circuit in a connected load: Disconnect the shorted electrical load. * Generator is overloaded: See “Don’t Overload the Generator”. * Engine speed is too slow or shorted generator circuit: Contact Authorized Service Facility.
Why does my Generac Power Systems GP shut down?
If your Generac Power Systems Portable Generator engine shuts down during operation, check the following: * Out of gasoline: Refill the fuel tank. * Low oil level: Fill the crankcase to the proper level. * Fault in engine: Contact an Authorized Service Facility.
Why won't my Generac Power Systems GP start?
If your Generac Power Systems Portable Generator won't start or runs rough, possible causes include: * The fuel shut-off is OFF: Turn the fuel shut-off to ON. * Dirty air filter: Clean or replace the air filter. * Out of or stale gasoline: Fill the fuel tank with fresh fuel after draining the old fuel. * Spark plug wire not connected: Connect the wire to the spark plug. * Bad spark plug: Replace the spark plug. * Water in the gasoline: Drain the fuel tank and fill it with fresh fuel. * Over-choking: Put the choke knob to the No Choke position. * Low oil level: Fill the crankcase to the proper level.
General| Brand | Generac Power Systems |
|---|---|
| Model | GP Series |
| Category | Portable Generator |
| Language | English |
