Convenient features
5-40
Bonnet
Opening the bonnet
OJX1050041ROJX1050041R
1. Park the vehicle and set the parking
brake.
2. Pull the release lever to unlatch the
bonnet. The bonnet should pop open
slightly.
OJX1059042 OJX1059042
3. Go to the front of the vehicle, raise
the bonnet slightly, push up the
secondary latch (1) inside of the
bonnet centre and lift the bonnet (2).
After the bonnet has been lifted
halfway, it will raise completely by
itself.
Closing the bonnet
1. Before closing the bonnet, check in
and around the engine room to ensure
the following:
- Any tools or other loose objects
are removed from the engine room
area or bonnet opening area
- All glove, rags, or other
combustible material is removed
from the engine room
- All filler caps are tightly and
correctly installed
2. Lower the bonnet halfway (lifted
approximately 30 cm (12 in.) from the
closed position) and push down to
securely lock in place. Then double
check to be sure the bonnet is secure.
If the bonnet can be raised slightly, it
is not securely locked. Open it again
and close it with more force.
WARNING
• Before closing the bonnet, ensure
all obstructions are removed from
around the bonnet opening.
• Always double check to be sure
that the bonnet is firmly latched
before driving away. Check there
is no bonnet open warning light
or message displayed on the
instrument cluster. Driving with the
bonnet opened may cause a total
loss of visibility, which might result in
an accident.
• Do not move the vehicle with the
bonnet in the raised position, as
vision is obstructed, which might
result in an accident, and the bonnet
could fall or be damaged.
EXTERIOR FEATURES