05
5-89
WINDSCREEN DEFROSTING AND DEFOGGING
WARNING
Windscreen heating
Do not use the
position during
cooling operation in extremely humid
weather. The difference between the
temperature of the outside air and
that of the windscreen could cause the
outer surface of the windscreen to fog
up, causing loss of visibility could cause
an accident resulting in serious injury
or death. In this case, set the mode
selection button to the
position
and fan speed control knob to a lower
speed.
• For maximum defrost performance,
set the temperature control to the
highest temperature setting and
the fan speed control to the highest
setting.
• If warm air to the floor is desired
whilst defrosting or defogging, set the
mode to the floor-defrost position.
• Before driving, clear all snow and ice
from the windscreen, rear window,
outside rearview mirrors, and all side
windows.
• Clear all snow and ice from the
bonnet and air inlet in the cowl grill
to improve heater and defroster
efficiency and to reduce the
probability of fogging up the inside of
the windscreen.
NOTICE
If the engine temperature is still cold
after starting, then a brief engine warm
up period may be required for the
vented air flow to become warm or hot.
To defog inside windscreen
OJX1050178ROJX1050178R
1. Select the desired fan speed.
2. Select the desired temperature.
3. Press the defroster button (
).
4. Fresh mode will be selected
automatically.
Check to make sure the air intake control
is in Fresh mode. If the air intake control
indicator light is illuminated, press the
button once to enable Fresh mode
(indicator light OFF).
If the
position is selected, the fan
speed is automatically increased.
To Next Page
Loading...
Need help?
General
