08
8-27
WARNING
Do not leave your vehicle running in
a poorly ventilated area for extended
periods of time. Carbon monoxide
poisoning and suffocation can occur.
Distributing the sealant
OOSH079022LOOSH079022L
9. Immediately drive approximately
4~6 miles or about 10 minutes to
evenly distribute the sealant in the
tyre.
Do not exceed a speed of 50 mph. If
possible, do not fall below a speed of
12 mph.
Whilst driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive with
caution until you can safely pull off of the
side of the road.
Call for road side service or towing.
Checking the tyre inflation
pressure
1. After driving approximately 4~6 miles
or about 10 minutes stop at a safe
location.
OJX1089032OJX1089032
2. Connect the filling hose (3) directly
into the tyre valve.
3. Connect cables (4) to the battery.
4. Adjust the tyre inflation pressure to
the recommended tyre inflation.
With the engine running, proceed as
follows.
-
To increase the inflation pressure:
Switch on the compressor.
To check the current inflation
pressure setting, briefly switch off
the compressor.
- To reduce the inflation pressure:
Press the button (9) on the
compressor.
NOTICE
Do not let the compressor run for more
than 10 minutes, otherwise the device
will overheat and may be damaged.
To Next Page
Loading...
Need help?
General
