Emergency situations
8-28
Information
The pressure gauge may show higher than
actual reading when the compressor is
running. To get an accurate tyre pressure,
the compressor needs to be turned off.
CAUTION
If the inflation pressure is not
maintained, drive the vehicle a second
time, refer to Distributing the sealant.
Then repeat steps 1 to 4.
Use of the TMK may be ineffectual for
tyre damage larger than approximately
0.16 in.
We recommend that you contact an
authorised Retailer of Genesis Branded
Products if the tyre cannot be made
roadworthy with the Tyre Mobility Kit.
WARNING
The tyre inflation pressure must be
inflated to the proper pressure (Refer to
“Tyre and Wheels” section in chapter 2).
If it is not, do not continue driving.
Call for road side service or towing.
CAUTION
Tyre pressure sensor
The sealant on the tyre pressure sensor
and wheel should be removed when
you replace the tyre with a new one and
inspect the tyre pressure sensors. We
recommend that you get this done at an
authorised retailer of Genesis Branded
products.
Information
When reinstalling the repaired or replaced
tyre and wheel on the vehicle, tighten the
wheel bolt to 14~16 kgf·m (101~116 lbf·ft).
To Next Page
Loading...
Need help?
General
