To Next Page

To Previous Page

June 2012

Part No. 228901 GS-30 • GS-32 • GS-46 • GS-47

TABLE OF CONTENTS

Section 3 Scheduled Maintenance Procedures, continued

Checklist B Procedures

B-1 Inspect the Batteries ........................................................................... 3 - 9

B-2 Inspect the Electrical Wiring ............................................................. 3 - 12

B-3 Inspect the Electrical Contactor ........................................................ 3 - 13

B-4 Inspect the Tires, Wheels and Castle Nut Torque ............................ 3 - 13

B-5 Test the Emergency Stop ................................................................. 3 - 14

B-6 Test the Key Switch .......................................................................... 3 - 15

B-7 Test the Automotive-style Horn (if equipped) .................................... 3 - 15

B-8 Test the Drive Brakes ....................................................................... 3 - 16

B-9 Test the Drive Speed - Stowed Position ........................................... 3 - 17

B-10 Test the Drive Speed - Raised Position ............................................ 3 - 18

B-11 Test the Slow Drive Speed ............................................................... 3 - 19

B-12 Perform Hydraulic Oil Analysis ......................................................... 3 - 20

B-13 Inspect the Hydraulic Tank Cap Venting System .............................. 3 - 20

B-14 Check the Module Tray Latch Components ...................................... 3 - 21

B-15 Inspect the Voltage Inverter (if equipped) ......................................... 3 - 22

B-16 Test the Down Limit Switch, Level Sensor

and the Pothole Limit Switches ......................................................... 3 - 23

B-17 Test the Up Limit Switch (if equipped)

and the Maximum Drive Height Limit Switches (if equipped) ............ 3 - 27

Checklist C Procedures

C-1 Test the Platform Overload Pressure Transducer and

Platform Height Sensor (if equipped) ................................................ 3 - 28

C-2 Calibrate the Platform Overload System (if equipped) ...................... 3 - 30

C-3 Replace the Hydraulic Tank Breather Cap -

Models with Optional Hydraulic Oil ................................................... 3 - 31

Checklist D Procedures

D-1 Check the Scissor Arm Wear Pads .................................................. 3 - 32

D-2 Replace the Hydraulic Tank Return Filter Element ........................... 3 - 34

Checklist E Procedure

E-1 Test or Replace the Hydraulic Oil ..................................................... 3 - 35

Genie GC-1530 User Manual

Questions and Answers: