28
There are two options to select from the IP Assignment:
Manually Assign or Assign Automatically Using.
Manually Assign
You can click “Manually Assign” and directly enter the IP
address.
The default settings are as follows:
• Default IP – 192.168.0.20
• Subnet Mask – 255.255.255.0
• Default Gateway – 0.0.0.0
Assign Automatically Using
If your network is using RARP, BOOTP or DHCP server, you
can click “Assign Automatically Using” and then click
“RARP”, “BOOTP” or “DHCP”. Under this setting the IPCam
SECURE300 will automatically assign an IP address from RARP,
BOOTP or DHCP server. Every time when the camera starts up,
please make sure that the DHCP server is set to assign a static IP
address to your camera.
If your application requires direct connection from an ADSL
modem through the IPCam SECURE300’s RJ-45 LAN port, and
you also have an ISP PPPoE account, click “PPPoE” option and
enter the Service Name, User ID and Password into the respective
fields. The IPCam SECURE300 will get an IP address from the
ISP as starting up.
To Next Page
Loading...