Operator Manual
Operation 4.15 © Genmega 2012
4.2.5 Loading the Receipt Paper
Step 1
Open the top Bezel. (See 4.1.4 Opening the top
Bezel.)
Step 2
Place the paper onto the supplied spindle with the
Coated Side Out as shown in the picture. Feed
the paper out through the back, where it will curl
back under the tension bar.
Step 3
Prepare the new paper roll. Note below.
NOTE:
1. Make sure the roll is in its proper roll form. (A deformed roll may cause jamming problems.)
2. When replacing the new roll, make sure the end of the roll paper is clean cut.
To Next Page
Loading...
Need help?
General